TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and | |||
follow the steps listed. If further assistance is needed, please see the front cover of this manual. |
| ||
PROBLEM: The power does not turn on |
|
|
|
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | |||
is plugged into a properly grounded outlet (see page 13). Use only a | |||
sor that meets all of the specifications described on page 13. IMPORTANT: The treadmill is not | |||
compatible with |
|
|
|
b. After the power cord has been plugged in, make sure that the key is inserted into the console. | |||
c. Check the reset/off circuit breaker located on the | c |
|
|
treadmill frame near the power cord. If the switch |
|
| |
protrudes as shown, the circuit breaker has | Tripped | Reset |
|
tripped. To reset the circuit breaker, wait for five |
| ||
minutes and then press the switch back in. | Position | Position |
|
PROBLEM: The power turns off during use |
|
|
|
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait | |||
for five minutes and then press the switch back in. |
|
|
|
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for | |||
five minutes, and then plug it back in. |
|
|
|
c. Remove the key from the console. Reinsert the key into the console. |
|
| |
d. If the treadmill still will not run, please see the front cover of this manual. |
|
| |
PROBLEM: The console displays remain lit when you remove the key from the console |
| ||
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a | |||
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off | |||
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE | |||
INFORMATION MODE on page 22 and turn off the demo mode. |
|
| |
PROBLEM: The displays of the console do not function properly |
|
|
|
SOLUTION: a. Remove the key from the console and UNPLUG | a | 73 |
|
THE POWER CORD. With the help of a second |
| ||
person, carefully tip the Uprights (73, 78) down. |
|
|
|
There may be two M4.2 x 16mm (12) in the bottom |
|
|
|
of the Belly Pan (69). If there are, remove them. |
|
|
|
Note: A Phillips screwdriver with a shaft at least 5 | 78 |
| 69 |
in. (13 cm) long is required. |
| ||
|
| 12 | 12 |
|
|
|
25