Lincoln Electric SVM194-A 78TROUBLESHOOTING and REPAIRF-78, See Figure F.14 for steps 14

Return to Section TOC Return to Master TOC

F-78TROUBLESHOOTING AND REPAIRF-78

GENERATOR FRAME

REMOVAL AND REPLACEMENT (continued)

FIGURE F.14 – CASE FRONT REMOVAL

STEP #16

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

STEP #15

STEP #14

See Figure F.14 for steps 14 - 16.

14. With the 9/16" wrench, remove the four bolts and lock washers holding the case front to the welder frame. There are two bolts on each side.

15. With the 1/2" wrench, remove the two bolts and nuts and washers from the fuel tank rails - one on each side.

16. Carefully clear and disconnect any necessary remaining leads and lift up and set the front panel assembly to the left side of the machine. Make sure all leads are clear.

Return to Section TOC Return to Master TOC

CLASSIC® 300D & 300G