Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

A3.6

INSTALLATION

A3.6

Battery ChargingWARNING

 

 

GASES FROM BATTERY can explode.

 

 

• Keep sparks, flame and cigarettes

 

 

away.

 

 

BATTERY ACID can burn eyes and

 

 

skin.

 

 

Wear gloves and eye protection and be

 

 

careful when boosting, charging or work-

 

 

ing near battery.

 

To prevent EXPLOSION when:

 

a) Installing a new battery - disconnect the

 

 

negative cable from the old battery first and

 

 

connect the negative cable to the new battery

 

 

last.

 

 

b) Connecting a battery charger - remove the

 

 

battery from the welder by disconnecting the

 

 

negative cable first, then the positive cable and

 

 

battery clamp. When reinstalling, connect the

 

 

negative cable last.

 

c) Using a booster - connect the positive lead to

 

 

the battery first, then connect the negative lead to

 

 

the ground lead on the base.

 

To prevent ELECTRICAL DAMAGE when:

 

a) Installing a new battery.

 

b)

Using a booster.

 

Use correct polarity - Negative Ground.

 

To prevent BATTERY DISCHARGE, if you have an

 

 

ignition switch, turn it off when engine is not

 

running.

 

 

To prevent BATTERY BUCKLING, tighten nuts on

 

 

battery clamp until snug.

 

------------------------------------------------------------------------

 

The CLASSIC® 300D KUBOTA is equipped with a wet charged battery. The charging current is automatically regulated when the battery is low (after starting the engine) to a trickle current when the battery is fully charged.

When replacing, jumping or otherwise connecting the battery to the battery cables, the proper polarity must be observed. This system is NEGATIVE GROUND.

CLASSIC® 300D & 300G

Page 58
Image 58
Lincoln Electric SVM194-A service manual Battery Charging Warning, A3.6, GAS ES from Battery can explode