Lincoln Electric SVM194-A service manual Optional Equipment, C5.2

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

C5.2		ACCESSORIES		C5.2
OPTIONAL EQUIPMENT		(Field Installed)	Wire Feed Module (K623-1) - Provides constant	volt-
Accessory Set (K704) - Includes 35 ft. (10.7m) elec-
trode and 30 ft. (9.1m) work cables, headshield, work			age (CV) output with improved arc stability for
clamp and electrode holder.			Innershield welding. Excellent for MIG welding.
			Recommended wire feeders are the LN-7, LN-23P and
	WARNING		LN-25.
			GFCI Receptacle Kit (K1690-1) - Includes one UL
Pipe Thawing with an arc welder can cause fire,			approved 115V ground fault circuit interrupter duplex
			type receptacle and installation instructions. Replaces
explosion, damage to electric wiring or to the arc			the factory installed 115V duplex receptacle. Each
welder if done improperly. The use of an arc welder			receptacle of the GFCI duplex is rated at 20 amps.
for pipe thawing is not approved by the CSA, nor is			Maximum total current from the GFCI duplex is limited
it recommended or supported by Lincoln Electric.			to 20 amps.
------------------------------------------------------------------------			TIG Module - Portable, high frequency unit with gas
Power Plug Kit (K802D) - A 20 amp power plug kit for
the auxiliary power receptacles is available. (Provides			valve for TIG welding. Rated at 300 amps / 60% duty
a plug for each receptacle.)			cycle. (Request Publication E3.205).
Remote Control Kit (K924-4) - Contains switch,			Order K930-2
			Control Cable - Connects TIG Module to the Classic®
receptacle, remote control rheostat, and 100 ft (30.5m)
cable for adjusting the OCV at the welding site.			300G.
Trailer (K953-1) - Two-wheeled trailer with optional			Order K936-4
			Arc Start Switch - Provides on/off control at the TIG
fender and light package. For highway use, consult
applicable federal, state, and local laws regarding pos-			Module.
sible additional requirements. Their is a choice of 2			Order K814
hitches, a fender & a light package. Order:			Contactor Kit - For use with TIG Module.
K953-1 Trailer
K958-1 Ball Hitch			Order K938-1
K958-2 Lunette Eye Hitch			Control Cable Extension - Allows the TIG Module to
K959-1 Fender & Light Kit.
K965-1 Cable Storage Rack			be operated at distances up to 200 ft. from the power
			source. Available length: 45 ft. (13.7m).
Remote	Control Kit (K924-5) - Contains a remote		Order K937-45
			Water Valve Kit - For use with a water-cooled TIG
control rheostat, and 100 ft. (30.5m) cable for adjust-
ing the OCV at the welding site.			Torch. Installs inside of TIG Module.
Remote	Control Kit (K2464-1) - Contains a remote		Order K844-1
			K2261-1 OIL DRAIN KIT - Includes ball valve, hose
control rheostat (for adjusting the CC “STICK” OCV),
remote control potentiometer (for adjusting the CV			and clamp.
“WIRE” OCV), and 100ft.(30.5m) cable.

Return to Section TOC Return to Master TOC

CLASSIC® 300D & 300G