Lincoln Electric SVM194-A service manual Wire Feed Options, C3.3

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

C3.3	ACCESSORIES		C3.3
WIRE FEED OPTIONS		M gnum Spool Gun (K487-25)-Hand held semiauto-
Wire Feed Module (K623-1) - Provides constant volt-
age (CV) output with improved arc stability for		matic wire feeder requires SG Control Module. 25 ft.
Innershield welding. Excellent	for MIG welding.	(7.6m)length.
Recommended wire feeders are the LN-7, LN-23P and		SG Control Module (K488) (For Magnum Spool
LN-25. (Factory installed on the K1643-6).		Gun) -The interface between the power source and
LN-25 Wire Feeder (K449)-Portable CC/CV unit for		the spool gun. Provides control of wire speed and gas
		flow.	(K691-10) ( For SG Control Module)
flux-cored and MIG welding. Includes Gas Solenoid &		Input Cable
Internal Contactor. Requires Wire Feed Module.		For Lincolnengine drives with 14-pin MS-type connec-
Remote Vol age Control Kit for LN-25 (K444-2)		tion provides separate 115V NEMA receptacle and out-
		put stud connections. 10 ft. (3.1m)length.
Provides 25 ft. (7.5m) of remote output voltage control
and output jumper (2 and 4) for machines having 14
pin MS-type connector.

ForMagnum®self-shielded350 Innewireshieldwith Gun15 ft(for. (4.LN5m)-25)(K126cable. -For2)-

.062-3/32” (1.6-2.8mm) wire.

With

15Magnum®ft. (4.5m)300cableMIG. ForGun.035”for-.045”LN-25(0K1802.9-1.2mm)-1-gas shielded (Includes Connector Kit).

Portable CV unit for InnershieldLN-23P WirepipeFeederwelding(K316L. Control-1)-cable operates con- tactor inside Wire Feed Module for “cold” electrode.

Requires LN-23P Adapter Kit (K350-1) and Gun and Cable Assembly.

Required to adapt LN- 23PLN-23Pto anyAdapterLincolnKitpower(K350source-1)- . Makes 14 pin con- nection at power source.

Magnum® 250 Innershield Gun (for LN-23P) (

For lighter weight and easier handling. RatedK355-25010)-amps, 60% duty cycle. For .068 through 5/64” (1.7 through 2.0 mm) Innershield wire and includes reduced speed switch. For pipe welding, an M11476 62° gun tube is recommended.

62° gun tube for PipeWelding (KP1909-1)- Recommended modification for K355-X or K345-X guns with 90° gun tubes. Compatible with K126-1,-2K264-8 and K355-10.

CLASSIC® 300D & 300G