Healthrider HRTL17980 manual TROUBLE-SHOOTING and Maintenance, Problemsolution

TROUBLE-SHOOTING AND MAINTENANCE

Most treadmill problems can be solved by following the instructions below. If further assistance is needed, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEMSOLUTION

1.The power does not turn on

a.Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See page 7.) Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b.Make sure that the key is fully inserted into the console.

c.Check the circuit breaker located on the frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d.Check the on/off switch located on the frame near the power cord. The switch must be in the on posi- tion.

Trippedi Reset

On

Position

2.The power turns off during use

a.Check the circuit breaker (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in.

c.Remove the key from the console and then reinsert it.

	d. Make sure that the on/off switch is in the on position (see d. above).
3. The walking belt	a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of
slows when walked	five feet or less in length.
on
	b. If the walking belt is overtightened, tread-	b
	mill performance may decrease and the
		3–4”
	walking belt may be permanently dam-
	aged. Remove the key and UNPLUG THE
	POWER CORD. Using the included allen
	wrench, turn both rear roller adjustment
	bolts counterclockwise 1/4 of a turn.
	When the walking belt is properly tight-
	ened, you should be able to lift the edges	Rear Roller Adjustment Bolts
	of the walking belt 3 to 4 inches off the
	walking platform. Be careful to keep the
	walking belt centered. Plug in the power cord, insert the key and run the treadmill
	for a few minutes. Repeat until the walking belt is properly tightened.
18	c. If the walking belt still slows when walked on, call our Customer Service
	Department toll-free.