Locate the Reed Switch (55) and the Magnet (54) on the left side of the Pulley (53). Turn the Pulley until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If necessary, loosen the #8 x 3/4" Tek Screw (80), move the Reed Switch slightly, and then retighten the Screw. Reattach the Motor Hood (not shown) and run the treadmill for a few minutes to check for a correct speed reading.
80 | 53 |
55 | 54 |
1/8 in. |
|
Top
View
SYMPTOM: The incline of the treadmill does not change correctly
a.Recalibrate the incline system (see step 3 on page 29).
SYMPTOM: The iFit Live mode does not function correctly
a.If the iFit Live mode is not functioning correctly, make sure that the treadmill has the most current firmware available (see step 6 on page 29).
SYMPTOM: The walking belt slows when walked on
a.Use only a
b.If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.
b
Idler Roller Screws
c.If the walking belt still slows when walked on, see the front cover of this manual.
34