7.With the help of a second person, hold the con- sole assembly near the Left Upright (88).
Route the Upright Wire (77) around the indicated crossbar. Then, route the Upright Wire through the looped ties on the bottom of the console as- sembly.
Connect the Upright Wire (77) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER.
8.Set the console assembly on the brackets onBe the Left and Right Uprights (88, not shown). careful not to pinch any wires.
Attach the console assembly with four 5/16" x 1 1/4" Patch Screws (4) and four 5/16" Star Washers (11) (only one side is shown). Start all four Patch Screws, but do not tighten them until assembly step 12 is completed.
Insert the excess Upright Wire (77) into the hole in the console assembly. Tighten the ties around the Upright Wire and cut off the ends of the ties.
7 |
| Console |
|
| Assembly |
Console | Crossbar | |
Wire | 77 | Ties |
Console | 88 |
|
|
| |
Wire |
|
|
77 |
|
|
8 | Console |
|
| Assembly |
|
77 | Ties | Bracket |
| ||
| 11 | 88 |
| 4 |
10
