2.Identify the Latch Assembly (76). Make sure that the sleeve has been slid over hole 1 and that the knob is locked into hole 1. Pull on the sleeve to make sure it is locked into place.
Next, make sure that the knob (46) is locked into hole 2. If it is not, pull out the tube until you see hole 2 and then slide the tube back in until the knob locks into hole 2.
2
Hole 2
| Knob |
Tube | Hole 1 |
|
Sleeve
76
3.Remove the plastic ties from the ends of the Latch Assembly (76).
Hold the Latch Assembly with the large barrel and knob positioned as shown; make sure all of the holes are aligned (see the inset drawings). Next, attach the lower end of the Latch Assembly to the bracket on the Upright (85) with the Lower Latch Bolt (3) and a Nut (20).
Then, attach the upper end of the Latch Assembly (76) to the bracket on the Frame (55) with the Upper Latch Bolt (4) and a Nut (20). Note: It may be necessary to move the Frame back and forth to align the Latch Assembly with the Bracket.
Lower the treadmill frame (see HOW TO LOWER THE TREADMILL FOR USE on page 25).
4.Remove the band securing the Upright Wire Harness (73) to the right Upright (85). Have a second person hold the console assembly near the right Upright.
Connect the Upright Wire Harness (73) to the wire harness extending from the console assembly.
Make sure to connect the connectors prop- erly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors into the right Upright (85).
3 |
| 55 |
|
|
|
| |
| 20 | 4 |
|
|
| Top | |
|
|
| |
|
| 76 | Holes |
| Knob |
|
|
Large
Barrel
| 85 | |
| Holes | |
20 | Bottom | |
3 | ||
| ||
4 |
| |
Console |
| |
Assembly |
| |
73 |
| |
85 |
| |
| 73 |
8
