Hearth and Home Technologies 6000GCF-IPIL E. Vent Diagrams, Top Vent - Horizontal Termination

E. Vent Diagrams
Top Vent - Horizontal Termination		WARNING
Note: The 6000 series fireplaces can adapt to	Fire Risk.	Explosion Risk.
	Do NOT pack insulation or other combustibles
SLP series vent pipe, if desired.
	between ceiling firestops.
When venting off the top of the unit, use a DVP-2SL adapter and	• ALWAYS maintain specified clearances around
a minimum 48 inch vertical section of SLP series vent pipe.	venting and firestop systems.
After the 48 inch vertical section, the venting table rules	• Install wall shield and ceiling firestops as speci-
must be followed. The first 48 inch vertical section is NOT	fied.
	Failure to keep insulation or other material away
counted as part of the vertical components in the table. It is
still counted as part of the overall maximum run. All venting	from vent pipe may cause fire.
table rules for the vent run must still be followed.
		WARNING
Example: DVP pipe 3 ft. min. vertical = 11 ft. max. horizontal	Fire Risk.
SLP pipe 7 ft. min. vertical = 11 ft. max. horizontal	• When using DVP-HRC-SS and DVP-HRC-ZC-
	SS termination caps on top vented fireplaces, a
	6 inch minimum vertical vent section is required
Top Vent - Horizontal Termination	before installing first elbow.
One Elbow	V1 Minimum		H1	Maximum
	6 inches	152 mm	3 ft.	914 mm
	1 ft.	305 mm	3 ft.	914 mm
	2 ft.	610 mm	6 ft.	1.8 m
	3 ft.	914 mm	9 ft.	2.7 m
V1	4 ft.	1.2 m	12 ft.	3.7 m
H1	V1 + H1 = 40 ft. (12.2 m) Maximum
		H1 = 20 ft. (6.1 m) Maximum
	V1 = 6 inches (152 mm) Minimum

Figure 7.3

Two Elbows

H2	V1
	H1

V1 Minimum		H1 + H2 Maximum
1 ft.	305 mm	Cannot do
1 1/2 ft.	457 mm	1-1/2 ft.	457 mm
2 ft.	610 mm	3 ft.	914 mm
3 ft.	914 mm	6 ft.	1.8 m
4 ft.	1.2 m	9 ft.	2.7 m

V1 + H1+ H2 = 50 ft. (15.2 m) Maximum

H1 + H2 = 17 ft. (5.2 m) Maximum

V1 = 1 ft. (305 mm) Minimum

	INSTALLED
Figure 7.4	HORIZONTALLY

24 Heat & Glo • 6000GCF-IPI, 6000GCF-IPILP • 2110-900 Rev. H • 11/08