Hearth & Home Technologies • BV4236DBI, BV4842DBI • 2209-900 Rev. N • 9/1234
Figure13.4FinishingMaterial1InchThickorLess
DOOR
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
Finishing materials 1 inch maximum thick.
Stop nishing material ush with opening.
FINISHING STRIP NOT USED
NON-COMBUSTIBLE
FINISHING MATERIAL
C. Doors
Only doors certied for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and nishing material is going to be used on the replace,
you may use the table below which shows the door mod-
els and the nishing material thickness allowed.
NOTICE: See service parts list (Section 16.B) for ordering
nishing strips. Finishing strips will not be needed for all
“Inside Fit” doors.
DOOR FIT FINISHMATERIAL
THICKNESS
SEE
FIGURE
Folio Inside Any 13.6
Arcadia Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Halston Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Chateau Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Galleria Overlap 1 inch or less 13.4
Inside Greater than 1 inch 13.5
Phoenix Inside Any 13.6
Harbor Inside Any 13.6
Arts & Crafts Inside Any 13.6
Modernist Inside Any 13.6
Jamestown Inside Any 13.6
Finishing Material Thickness: 1 Inch ThickorLess
Note:Finishing strips may be used to aid in positioning of
non-combustible facing materials for some of the door com-
binations in the table above. Use nishing strips with “Over-
lap” t doors. They must be removed following nishing
work. See gure 13.7.