9 Operating Instructions
A. Before Lighting Appliance
Read this entire manual prior to using the appliance. Failure to follow the instructions may result in property damage, bodily injury, or even death.
•Remove all shipping materials from inside and/or underneath the firebox.
•Review proper placement of logs, mineral wool.
•Check the wiring.
•Check the baffle adjustment.
•Ensure that there are no gas leaks.
•Ensure that the glass is sealed and in the proper posi- tion.
•Ensure that the flow of combustion and ventilation air is not obstructed (front grilles and vent caps).
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualified installer, service agency or the gas supplier.
WARNING
Do NOT use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
WARNING
Glass door must be in place when appliance is operating.
Risk of:
•Combustion Fumes
•Fire
Do NOT operate appliance with glass door removed.
•Open viewing glass for servicing only.
•Glass door MUST be in place and sealed before operating appliance.
•Only use glass door certified for use with appliance.
•Glass replacement should be done by qualified technician.
WARNING
HOT SURFACES!
Glass and other surfaces are hot during operation AND cool down.
Hot glass will cause burns.
• Do not touch glass until it is cooled
•NEVER allow children to touch glass
•Keep children away
•CAREFULLY SUPERVISE children in same room as fireplace.
•Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other flammable materials.
•Keep clothing, furniture, draperies and other flammable materials away.
B. Controls
FAN SPEED: This knob controls the speed of the blower that pushes the heated air into the room.
MAIN BURNER: This control is used to turn the appliance on and off.
PILOT IGNITOR: The pilot ignitor is used only to start the pilot. When the valve control knob is turned to the pilot position and fully depressed press the piezo ignitor repeatedly creating a blue spark directly next to the pilot, igniting the pilot flame.
VALVE CONTROL: This knob is used to control gas to the appliance and for starting the pilot. There are three positions, ON, OFF, & PILOT. The indicator on the valve indicates the position of the knob.
COMFORT CONTROL: This knob controls the flame height from low (“LO”) to high (“HI”).
NOTE: If using a remote control wall switch, or thermostat, the On/Off Switch must be left “OFF”. Turning the On/Off Switch to “ON” will keep the appliance on continually.
10/08 | Page 33 |
