Hearth and Home Technologies Cyclone-BN, Cyclone-BC owner manual Hot Surface Ignition Wiring

C. Hot Surface Ignition Wiring

This appliance requires a 110 VAC supply to the appliance terminal block for operation. A wiring diagram is shown in Figure 10.3.

This appliance is equipped with a 24V valve.

Optional Accessories Requirements

Wiring for optional accessories should be done now to avoid reconstruction.

CAUTION

Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING

Shock hazard.

•Replace damaged wire with type 105º C rated wire.

•Wire must have high temperature insulation.

			GROUND	FAN MOTOR
			(L1) 120-BLACK
			(N) NEUTRAL-WHITE
REMOTE
	8
		24 VOLT TRANS	3
	2			2
		1	5
				SENSOR
			9
7	6
		CONTROL MODULE
			4
	HOT SURFACE IGNITOR	1		3
	(HSI)
ITEM	PART DESCRIPTION			COLOR(S)
1	(M)L1 - (M)F1 - (T) 23 -	-120V		Black
2	(FT) BTM-IGN-(T)1- +120V			Black/White
3	(V)1 & (V)3 - GND & (T)4			Blue/Green
4	(V)2 & (V)4 - (M)MV1			Red
5	(M) F2 - (FT) TOP			White
6	(M)S1-IGN			White
7	FEMALE RECEPTACLE PLUG			Black/White/Green
8	REMOTE WITH PIGTAIL - (M)W OPTIONAL			Red
9	(M)R - (M)W - (M)P.SW - REM/WS			Red
Figure 10.3 Wiring diagram
	Heat & Glo • Cyclone-BN, Cyclone-BC • 2073-900 Rev. N • 10/08			31