Figure 14.2 The glass platform plate can now be removed by removing the 10 screws on the outer edge of this platform.
Figure 14.3 Lift the platform. The HSI (Hot Surface Ignitor) and the sensor wire can be unplugged. Set platform aside.
Figure 14.4 Remove the tube burner. It is held in place with one screw. Pull the burner tube away from orifice holder, rotating burner tube slightly, and remove it from the orifice.
Figure 14.5 The fan plate can now be accessed. Remove the four screws. Lift the fan plate, being careful to not cut or scar wiring while disconnecting them from the fan motor.
B. Side Reflector Panel Installation
To install the reflector panels, insert the panel by aligning the teeth on the panel with the slots in the back of the appliance.
TEETH
SLOT
TEETH
Figure 14.6 When screwing the panel in place start with the center screw and with your free hand lift the panel up so that it comes in contact with the top reflector panel. Insert all screws until finished.
Heat & Glo • | 39 |
