Exhaust Hood
An exhaust hood must be installed over your new appliance. (see fig. 2) Exhaust hoods to match the Legacy and Metro cooktops are available from your dealer. Our hoods are designed and built to complement your range’s visual appeal and performance.
Should you wish to install an exhaust hood of your own choice, ensure that the exhaust hood you purchase is the correct size and capacity for your Heartland cooktop. Please follow the exhaust hood manufacturers installation instruc- tions. When installing an after market exhaust hood over a Heartland cooktop we recommend that you use the clearances as shown in the clearance diagrams for exhaust hood installa- tions. See page
Venting Safety Guidelines:
Installation must be completed in accordance with all local and national codes. Use only materials which conform to local codes in effect. Be sure the power is disconnected before doing any electrical work. All duct work must be metal. Do not use plastic duct. The hood should never be exhausted into a wall cavity or an attic where an accumulation of grease could become a fire hazard. When the installation is completed, turn on the fan and make sure that there are no obstructions in the line.
Electrical Installation
Electrical requirements: standard 120 volts 60 Hz .375 Kw volt receptacle, properly polarized, on it’s own line. Cooktops are supplied with a 3 prong 5 ft. (1.5 m) moulded plug cap power cord.
Models 3800/3820 and 3805/3825 gas cooktops must be electrically grounded in compliance with local codes. In the absence of local codes, the installation must conform with the National Electrical Code.
Disconnect the electrical supply and turn off the gas supply before servicing the appliance.
Gas Line Installation
Gas requirements: 30” and 36” Heartland gas cooktop models can be operated with either natural gas or liquid propane (LP). The cooktops are set for either natural gas OR propane at the factory. A conversion kit may be purchased at a later time and installed on site should the need arise. The cooktop requires a ½” NPT connector. Use minimum 5/8” diameter flexible line. Note: This unit contains a
The cooktop must be installed in compliance with local codes. In the absence of local re- quirements, the installation must conform with the National Gas Code.
Note: Appliances installed in the state of Massachusetts:
- This appliance can only be installed in the state of Massachusetts by a Massachusetts licensed plumber or gas fitter
During any pressure testing of the gas supply piping system, at test pressures equal to or less than 2.5 KPS, the cooktop must be isolated from the gas supply piping system by closing its individual manual shutoff valve.
The maximum propane/natural gas supply inlet pressure must not exceed 14” of water column. The minimum gas supply inlet should be at least 6” of water column for natural gas or at least 11” of water column for LP gas.
11
