Heat & Glo LifeStyle BE-41LPC, BE-41C LOG ASSEMBLY: LOGS-6000BE, F. Install the Log Assembly

F. Install the Log Assembly LOG ASSEMBLY: LOGS-6000BE

CAUTION! Logs are fragile! Handle with care.

1.Release four glass clips and set the glass assembly aside.

NOTE: See Step 9 when replacing the log set in an existing fireplace.

2.Carefully cut the cable tie holding the log assembly in place and discard the tie. Do not leave any part of the tie in the fireplace. See Figure 2.

CAUTION! Risk of Cuts, Use wire cutters.

DO NOT attempt to cut the tie with a knife.

3.Grasp the log assembly by the ends. Do NOT grasp the log assembly by the center. Remove the log assembly from the fireplace and set aside.

4.Remove the foam pad from the fire- place and discard. Make sure all pieces of the foam are removed. With a screwdriver bend up the log place- ment tabs. See Figure 3.

Figure 1

Figure 2

Log P lacem ent Tabs

Figure 3

2024-925D 4/09

54 Heat & Glo • BE-41C / LP, BE-41IPIC / LP • 2105-900 Rev. P • 6/09