Heat & Glo LifeStyle CERONA-42, CERONA-36 owner manual Model Cerona-42

Model: Cerona-42 Log Assembly: LOGS-Cerona42

If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the following instructions.

51

2 3 6

4

GRATE

TAB

Figure 12.12 Figure 12.13

CAUTION: Carefully remove the logs from the packaging. Logs are fragile!

STEP 1. Attach grate by lining up grate tab with pilot holes. Secure with two screws. See Figure 12.13.

STEP 2. LOG #1 (SRV2107-701):

Place log #1 over the back side of the burner plate and slide forward until log hits the grate. Log cut out should fit over pilot bracket. See Figure 12.14.

1

Figure 12.14

STEP 3. LOG #2 (SRV2107-702):

Fit log #2 on the right side of the grate. The log is formed so it will sit around the right grate bar. Rest the top of the log on the flat section of log #1. See Figure 12.15

2

FORM FITTED

TO GRATE TINE

Figure 12.15

2107-935

40 Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. A • 6/06