Heat & Glo LifeStyle CERONA-36, CERONA-42 owner manual Finishing Material Options, Risk of Fire

WARNING

Risk of Fire

• Non-combustible clearances must be maintained.

•Sheetrock, wood or other combustibles must NOT be used as sheathing or facing in the non-combustible zone.

•See Section 11 for proper clearances.

•See Section 1 for combustible/non- combustible definitions.

C.Finishing Material Options

Finishing Material Thickness from 3/4 in. to 1-1/4 in.

Finishing material within this thickness range can be brought to 1/2 inch behind the door top and sides. These non-com- bustible finishing materials must never overlap or obstruct the air outlet/inlet grille areas.

	NON-COMBUSTIBLE FINISHING MATERIAL
HEADER	(INSTALLED OVER NON-COMBUSTIBLE
	FACING MATERIAL)

B

1IN.

(25mm)

A

		A	B
Cerona-36	in.	43-5/8	50-3/16
	mm	1108	1275
Cerona-42	in.	50-5/8	54-3/8
	mm	1286	1381

Non-combustible facing material is supplied with this appliance. This material extends from the header to one inch above the appliance bottom and from framing stud to framing stud.

Figure 11.4

IMPORTANT INSTALLATION NOTE

Please note that there are four holes or dots on the template to assist in positioning the template. These holes or dots should line up with the door mounting holes on the unit to ensure proper placement of the door after finishing materials are installed.

Finishing Material Thickness greater than 1-1/4 inch

A steel template (Cerona-36 Template or Cerona-42 Tem- plate) is available for purchase to use instead of construct- ing a template.

R I

Ø H

A		G
		B
		C
	D	F
		E

		A	B	C	D	E
Cerona-36	in.	34-1/2	23-9/16	5-3/16	1-1/4	38
	mm	876	598	132	32	965
Cerona-42	in.	38-7/8	25-1/4	3-5/8	2-5/8	46-1/4
	mm	987	641	92	67	1175

		F	G	H	I
Cerona-36	in.	1-1/4	28-13/16	3/8	34-5/8
	mm	32	732	10	879
Cerona-42	in.	2-5/8	31-7/16	3/8	39-5/8
	mm	67	799	10	1006

Figure 11.5 Facing Template Dimensions

Mounting stone eye brow: ATRIMSTONE-36, ATRIMSTONE-42

NOTE: When mounting ATRIMSTONE-36 OR ATRIMSTONE-42 you must install template or front to insure proper positioning. Failure to do so will result in the front not fitting (see Figure 11.5).

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. A • 6/06 35