Heat & Glo LifeStyle EVEREST manual Finishing, LET/OUTLET Grilles in ANY Manner

Step 9. Finishing

The following diagram shows the minimum vertical and corresponding maximum horizontal dimensions of fireplace mantels or other combustible projections above the top front edge of the fireplace. See Figures 2 and 3 for other fireplace clearances.

Only non-combustible materials may be used to cover the black fireplace front.

WARNING: WHEN FINISHING THE FIREPLACE, ! NEVER OBSTRUCT OR MODIFY THE AIR IN-

LET/OUTLET GRILLES IN ANY MANNER.

						CEILING
			12"
			11"
		10"
	9"					31”
	8"
6"	7"
						12”
5"						11”
4"						10”
3"			6”	7”	8”	9”
2"	4"	5”
3”
2”

TOP FRONT EDGE

OF FIREPLACE

Figure 24.

Minimum Vertical and Maximum Horizontal Dimensions of Combustibles above Fireplace

CAUTION: IF JOINTS BETWEEN THE FINISHED WALLS AND THE FIREPLACE SURROUND (TOP AND SIDES) ARE SEALED, A 300° F. MINIMUM SEALANT MATE-

RIAL MUST BE USED. THESE JOINTS ARE NOT RE- QUIRED TO BE SEALED. ONLY NON-COMBUSTIBLE MATERIAL (USING 300° F. MINIMUM ADHESIVE, IF NEEDED) CAN BE APPLIED AS FACING TO THE FIRE- PLACE SURROUND. SEE THE DIAGRAM BELOW.

FINISH WALL MATERIAL MAY BE COMBUSTIBLE
	- TOP AND SIDES
		0”
	HIGH TEMPERATURE
	(3000F. / 149 0C. MIN.)
	TOP & SIDE
	SEAL JOINT
	1/2”	1/2”
Figure 25.	Sealant Material

Hearth Extensions

A hearth extension may be desirable for aesthetic reasons. However, ANSI or CAN/CGAtesting standards do not require hearth extensions for gas fireplace appliances.

Heat & Glo • Everest • 750-900 Rev. L • 1/06 24