Heat & Glo LifeStyle st-42tvfl manual For Direct Spark Ignition DSI Wiring, Appliance Requirements

					476-500
OPTIONAL REMOTE,	HI TEMP				DSI CONTROL VALVE
		L2
WALL SWITCH
	LIMIT SWITCH
OR THERMOSTAT		(NEUTRAL)
(ON CERTIFIED UNITS ONLY)
	100-254A	L1		OPTIONAL
	JUNCTION
				FAN		459-591
	BOX	(HOT)
				SWITCHES		IGNITOR
	120 VAC
	BLACK
ON/OFF					WHITE	GE
		REM	FAN		BLUE		501-592
						NA
							DSI
						RO
			GROUND				MODULE
					WHITE
					YELLOW
		GROUND			GREEN
		TO
		FIREPLACE			BLUE
		CHASSIS		WHITE
				BLACK
FLAME SENSOR/SPARKER
	HI-TEMP			ON/OFF SWITCH
	LIMIT SWITCH
IGNITION	GAS
MODULE	VALVE
	REMOTE OUTLET
		FAN OUTLET		CONNECTORS
NEUTRAL					HOT
	GROUND

Figure 12. Direct Spark Ignition (DSI) Wiring Diagram

For Direct Spark Ignition (DSI) Wiring

Appliance Requirements

This appliance requires that 110-120 VAC be wired to the factory installed junction box. Maintain correct polarity when wiring the junction box.

Optional Accessories

Optional remote control kits require that 110-120

VAC be wired to the fireplace junction box.

Wall Switch

Position the wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less of 16 A.W.G. minimum wire and connect it to the fireplace ON/OFF switch pigtails.

CAUTION	LABEL ALL WIRES PRIOR TO
	DISCONNECTION WHEN SERVICING
	CONTROLS. WIRING ERRORS CAN CAUSE
	IMPROPER AND DANGEROUS OPERATION.
	VERIFY PROPER OPERATION AFTER

SERVICING. 25