Step 12
Before Lighting
the Fireplace
Step 13
Lighting the
Fireplace
After the
Installation
Before lighting the fireplace, be sure to do the following:
Remove all paperwork and documents from underneath the fireplace.
Review safety warnings and cautions
•Read the Safety and Warning Information section at the beginning of this Installers Guide.
•Before lighting the fireplace,
•Before lighting the fireplace,
•Any component that is found to be faulty MUST BE replaced with an approved component. Tam- pering with the fireplace components is DANGER- OUS and voids all warranties.
A small amount of air will be in the gas supply lines. When first lighting the fireplace, it will take a few minutes for the lines to purge themselves of this air. Once the purging is complete, the fireplace will light and will operate normally.
Subsequent lightings of the fireplace will not require this purging of air from the gas supply lines, unless the gas valve has been turned to the OFF position, in which case the air would have to be purged.
NOTE: The fireplace should be run 3 to 4 hours on the initial
You’ve reviewed all safety warnings, you’ve checked the fireplace for gas leaks, you know the vent system is unobstructed, and you’ve checked for faulty components. Now you’re ready to light the fireplace.
!WARNING: PLEASE REFER TO THE US- ER’S MANUAL FOR ALL CAUTIONS, SAFETY, AND WARNING INFORMATION PERTAINING TO THE LIGHTINGAND OP- ERATION OF THE FIREPLACE.
LEAVE THIS INSTALLATION MANUAL WITH THE APPLIANCE FOR FUTURE REFERENCE.
29