C. Check Pilot Flame Appearance
Pilot flame must contact the thermocouple and thermopile for reliable appliance operation.
•Pilot flame should be as shown in Figure 12.1.
Figure 12.1 Proper Pilot Flame
•If adjustment is needed remove cap screw from gas valve using 1/8 inch standard screwdriver (see Figure 12.2).
•Turn adjustment screw clockwise to increase pilot flame size. Make small adjustments.
PILOT |
ADJUSTMENT |
Figure 12.2 Adjustments |
•Do NOT turn adjustment screw
•Replace cap screw and seal to prevent gas leaks.
•Check for gas leaks after tightening.
D. After Appliance is Lit
WARNING
Glass door must be in place when appliance is operating.
Risk of:
•Combustion Fumes
•Fire
Do NOT operate appliance with glass door removed.
•Open viewing glass for servicing only.
•Glass door MUST be in place and sealed before operating appliance.
•Only use glass door certified for use with appliance.
•Glass replacement should be done by qualified technician.
Initial Break-in Procedure
When you light the appliance, you may notice that it pro- duces heat which does have an associated odor or smell. If you feel this odor is excessive it may require the initial three to four hour continuous burn on high followed by a second burn up to 12 hours to fully drive off any odor from paint and lubricants used in the manufacturing process. Condensation of the glass is normal.
Note: The appliance should be run three to four hours on the initial
During this
30 | Heat & Glo • |
|
