GC150 SERIES DIRECT VENT GAS APPLIANCE
WARNING!
CHILDREN AND ADULTS SHOULD BE ALERTED TO THE HAZARDS OF HIGH SURFACE TEM- PERATURES AND SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING IGNITION. YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED WHEN THEY ARE IN THE SAME ROOM AS THE APPLIANCE.
CAUTION:
ANY SAFETY SCREEN OR GUARD REMOVED FOR SERVICING AN APPLIANCE MUST BE REPLACED PRIOR TO OPERATING THIS APPLIANCE.
CLOTHING OR OTHER FLAMMABLE MATERIAL SHOULD NOT BE PLACED ON OR NEAR THE APPLIANCE.
Before operating this appliance, please review the safety precautions given on page 2 as well as the items listed below:
1.Check to make sure the logs, rock wool and lava rock have all been placed correctly. (Refer to Steps 12 and 13 on page 17 and 18). The top of the burn- er and the holes in the sides of the burner should not be covered with rock wool. If these items are not visible, please adjust before continuing.
2.Check to see that all wiring is correct and enclosed to prevent possible shock. This is done by removing the lower panel (see Step 1 follow- ing) to access the control area.
3.Check to ensure there are no gas leaks. This may be done with a soap and water solution.
4.Make sure the front glass is sealed and in its proper position. Never operate this appliance with the glass removed or not sealed.
5.Verify that all venting and caps are unobstructed. Exhaust gases are extremely hot. Be sure there are no possible future obstructions from trees, bushes, snow drifts, etc. A CS cap shield can be purchased to help prevent possible contact.
6.Read and understand these Instructions thorough- ly before attempting to operate this appliance.
STEP 1- Lower Panel Removal
To remove the lower panel, gently lift and pull on the outside top edges of the panel as shown in Figure 34.
To replace the panel, reverse this action.
If you own an electronic ignition, at this point skip section A on the following page and continue with section B on page 22.
Figure 34
Lower Panel Removal
21 | 21322K |
