Henny Penny CMC/CMR-105, CMC/CMR-106 Installation, Introduction, shock could result, Unpacking

Model CMC/CMR-103,104,105,106,107

SECTION 2. INSTALLATION

2-1. INTRODUCTION This section provides the installation for Henny Penny cold tops.

Installation of this unit should be performed only by a qualified service technician.

	Do not puncture the unit with any objects such as
	drills or screws, or component damage or electrical
	shock could result.
2-2. UNPACKING	The Henny Penny Cold Top has been tested, inspected, and
	expertly packed to insure arrival at its destination in the best
	possible condition. The grids, side glass, and sliding thermal doors
	are packed separately inside the unit. The cabinet rests on a
	wooden skid and is then packed inside a heavy cardboard carton
	with sufficient padding to withstand normal shipping treatment.

To avoid damage to the components, do not lay the unit on its side. If the unit has been on its side, the unit must be in an upright position for at least 4 hours before power is applied to the unit.

Check all components, for signs of being loose or dam- aged, and make sure the system has refrigerant.

When moving the cold top be careful not to damage the refrigerent circuit.

Any shipping damage should be noted in the presence of the delivery agent and signed prior to his or her departure.

To remove the Henny Penny cold top from the carton:

1.Carefully cut banding straps.

2.Lift the carton off the unit.

3.Remove bolts securing the cold top to the skid and lift the

unit off the skid.

303 2-1