Henny Penny CMC/CMR-103 Continued, Take care when moving the fryer to prevent personal, Model No

Model CMC/CMR-103,104,105,106,107

2-2. UNPACKING
(Continued)
	Take care when moving the fryer to prevent personal
	injury or damage to the refrigeration system. The
	CMC-107s weigh over 700 lbs. (318 kg).
4.	Peel off any protective covering from exterior of the cabinet.
5.	Install the grids into unit.
6.	Unpack sliding thermal doors and side glass. Install on rear
	and side of unit.
7.	Your cold top is now ready for operation.

2-3. ELECTRICAL	The Cold Top is available as a 120 VAC, 60 Hz. or 230VAC,
	50 Hz., single phase unit, both for domestic and international use.
	The data plate, located beside the power cord, specifies the correct
	electrical supply. The Cold Tops are shipped with cord and plug,
	and requires a grounded receptacle with a separate electrical line
	protected by a fuse or circuit breaker of the proper rating. Position
	the unit so the power cord receptacle is accessible.

To avoid electrical shock, this appliance must be equipped with an external circuit breaker which will disconnect all ungrounded (unearthed) conductors.

Refer to the table below for electrical ratings:
Model No.	Volts	Amps	Phase	Max. Fuse Size
CMC-103	120	7.7	1	15
CMC-103	230	4.5	1	15
CMC-104	120	7.7	1	15
CMC-104	230	4.5	1	15
CMC-105	120	8.6	1	15
CMC-105	230	6.0	1	15
CMC-106	120	8.6	1	15
CMC-106	230	6.0	1	15
CMC-107	120	9.5	1	15
CMC-107	230	7.7	1	15
2-2				303