Hi-Touch Imaging Technologies CS-300 Please install a new ribbon, Ribbon out, properly, Door open

		1.	Please install a new ribbon.
		2.	Please follow the instructions from the LCD display to
			switch the ribbon sensors (Please refer to Chapter 3,
Ribbon out	The ribbon has been used up.		section 2, the description of RIBBON 1)
		If the error message still occurs, please contact your
		nearest HiTi distributor or HiTi customer service center.
		Website: http://www.hi-ti.com
		1.	Please make sure the ribbon is present.
		2.	Please make sure the ribbon has been installed
			properly.
		3.	Please clean the chip on the side of the ribbon and
Ribbon missing	The card printer does not detect the		re-install the ribbon to the card printer.
	ribbon.	4.	Please close the ribbon door properly.
		If the error message still occurs, please contact your
		nearest HiTi distributor or HiTi customer service center.
		Website: http://www.hi-ti.com
	The ribbon is not installed or the ribbon	1.	Please check if the ribbon is present.
Door open	is installed in an improper position or	2.	Please make sure the ribbon has been properly
	the ribbon door is in the correct		installed, remove and re-install the ribbon if necessary.
	position.	3.	Please close the ribbon door to the proper position.
		1.	Please remove the ribbon.
		2.	Please clean the chip in the side of the ribbon and
			re-install the ribbon.
Ribbon IC R/W	An error occurs in the chip.	3. If the error message still exists, please install a new
error			ribbon.
		4.	If the error message still occurs, please contact your
		nearest HiTi distributor or HiTi customer service center.
		Website: http://www.hi-ti.com
Unsupported ribbon	Wrong ribbon for this printer.	Please install the correct ribbon.
Unknown ribbon	The ribbon can not be recognized.	Please install the correct ribbon.

38 www.hi-ti.com