USING THE REMOTE TO CONTROL DVD FUNCTIONS
Operating the precoded function for your DVD player,
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player (refer to page 40 for
1.Turn ON your DVD player.
2.Aim the remote control at the front of your DVD player.
3.Press and release the DVD button to switch to DVD
4.Hold down the DVD button on the remote and enter the two digit preset code that matches your DVD player, as shown on page 40. The indicator light will flash 3 times if the code was accepted.
5.Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different two digit preset code.
6.The remote will now control your DVD player.
7.You will need to set the display type of your DVD player to 16:9 widescreen.
NOTES:
1.If your DVD player cannot be operated after performing the above procedures, your DVD player's code has not been precoded into the remote.
2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.
3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.
(_) DVD Button
This button allows the remote to control your DVD player by setting it to DVD mode.
(_) PRECODED DVD Buttons
These buttons transmit the chosen precoded DVD codes.
(_) EXCLUSIVE TV Buttons
These buttons are for operating the TV.
tO) (D (D]
tt(D (D ®t
t(D (D (D_
oo oP0
[Q O O
¢-
HFI_CH!
MY DVD PLAYER CODE IS:
i!i i i
iii:miiii@
ii!i il
ilZii!ii
i:i_iiiiii
i!i_!i!i
I
I
NOTE: | Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player. |
I
I
37
