Hitachi 51S700, 57S700, 65S700 CD, AMP buttons, Channel selector buttons, Sleep and -DASH button

HOW TO USE THE REMOTE TO CONTROL YOUR TV

(_CD, AMP buttons

When pressed, each of these buttons will blink to indicate the remote is in Audio mode (see page 39).

(_) CHANNEL selector buttons

CHANNEL selector buttons are used to select channels, lock access code, etc.

Enter one, two, or three numbers to select channels. Enter "0" first for channels 1 to 9, or simply press the single digit channel you wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the "1" button, wait until two dashes appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.

Channel selection may also be performed by pressing CH up (A) or down (•).

When in ANT C, digital channels are indicated by the use of a (_) DASH in the subchannel number (for example "15-1"). Press buttons [0], [1], [5], [1] to tune to subchannel 15-1 or buttons [0], [1], [5], [0], [0], [1].

I NOTE: The TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode (see page 51).

(_) SLEEP and (-)DASH button

Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15 minutes to this timer, up to a maximum of three hours. Once set, use INFO when you want to view time remaining. If the SLEEP button is pressed while the timer is set, it will reset to the original condition.

When in ANT C, Digital channels are indicated by the use of a (-) DASH in the subchannel number (for example "15-1"). Press buttons [1], [5], [-], [1] to tune to subchannel 15-1.

(_) INFO button

Press this button when you want to check the channel being received, the picture source, if the channel has stereo (ST) or second audio program (SAP), the time, CHANNEL ID and if the TIMER is set.

iii_ii

iii i !i

iii (i,]

iiiOi i¸

ANT A/ANT B

					3:32 PM
					Ant A 22
					Stereo
					R
					1080i Format
					Mode
	Day/N
Closed	Moc
Captioning	--	-_	QOff	Q,,0:00 AM	_pTimer
				t
				Off Timer	Virtual HD

an S-VIDEO Input is connected to VIDEO: 3.

a

COMPONENT

VIDEO: Y-PBPR Input is connected to

VIDEO: 1.

iiim

iiiZ;;

iii_

h

	ANT C				IEEE1394
	blain	Picture
	Source				When an IEEE1394 device
					Esconnected
			TV Time
Program Name	--	KpBS,,DT	• Channel	ID
and Information	_ho's Who _tL t_he ZOO				" Multi
			• Program	Time
					Channel
			• Digital Closed Caption		Programs

•Broadcast Raling

•Program Language

•Digital Inp{_t Signal

Day/N _ht

Closed Mo(

Captioning --				--	S_eep Timer
- -_"	I©off@]Day	rBe _,, 4:3Expanded000 Abl	E_1080it	_l--
	Wide Mode Off Timer		Virtual HD

NOTES: 1. When an IEEE1394 device is connected, press CH A, CH • buttons to change Multi Channel programs.

2.When in ANT C or a 1394 device, press the INFO button twice (2x) to see detailed program information when available.

23