English
Head |
| Head |
|
r | Bevel Angle Scale |
|
|
|
| Bevel Angle Scale | |
|
|
| |
| q | e | w |
|
|
| |
| Fence | Fence |
|
| Base |
| Base |
Miter Angle |
|
| |
Turntable | Turntable | Miter Angle | |
Scale |
|
| Scale |
| Fig. 34 |
| Fig. 36 |
Fence |
| Fence |
|
|
|
| |
B | A | A | B |
| |||
| Table on Base |
| Table on Base |
| Fig. 35 |
| Fig. 37 |
11. Groove cutting procedures
Cut grooves with saw blade
| 8mm Depth Adjustment Bolt | |
a | 8mm |
|
Wing Nut |
| |
| b |
|
b |
|
|
| Bottom Line of |
|
| the Groove | Turntable |
Fig. 38 |
| Fig. 39 |
Grooves in the workpiece can be cut as indicated in Fig. 38 by adjusting the 8mm depth adjustment bolt.
Cutting depth adjustment procedure:
(1)Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand.
(2)Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of the base (see b in Fig. 38).
(3)The 8mm wing nut must be properly tightened after the adjustment has been completed.
NOTE: When cutting a single groove at either end of the workpiece, remove the unneeded portion with a chisel.
22
