Hitachi C 10FS instruction manual Practical Applications, Using an ink line

English

7. Stopper for precision cutting ... (Stopper is optional accessory)

WorkpieceStopper

Holder

The stopper facilitates continuous precision cutting in lengths of 10-7/16" to 16-15/16" (265mm to 430mm).

To install the stopper, attach it to the holder with the 6mm knob bolt as shown in Fig. 13.

6mm Knob Bolt

Fig. 13

8. Using an ink line

Saw Blade Groove

Guard

Workpiece

	(1) Right angle cutting
	Loosen the 8mm knob bolt and contact the tip of the guard
	with the workpiece.
	Aligning the ink line on the workpiece with the groove of the
8mm	guard, the workpiece is cut on the ink line (Fig. 14).
Knob Bolt

Marking (pre-marked)

Move the

Fig. 14

8mm Knob Bolt

Safety

Cover

Guard

(2)Miter cutting and compound cutting (Miter cutting + bevel cutting)

Upon lowering the motor section, the safety cover is raised and the saw blade appears.

Align the ink line with the saw blade (Fig. 15).

Guard Backward

Fence (B)

Marking	CAUTION: In some arrangements when the turntable is
(pre-marekd)	rotated, the guard projects from the fence sur-
	face. Loosen the 8mm knob bolt and push the
	guard to the retracted position. Never lift the
	safety cover while the saw blade is rotating.

Fig. 15

PRACTICAL APPLICATIONS

WARNING: * To avoid personal injury, never remove or place a workpiece on the table while the tool is being operated.

*Never place your limbs inside of the line next to warning sign while the tool is being operated. This may cause hazardous conditions (see Fig. 16).

Line Warning Sign Warning Sign Line

Fig. 16

15