Hitachi C 10FS instruction manual

English

(2)Setting to cut crown moldings at positions w and e in Fig. 29 (see Fig. 32; tilt the head to the left): q Turn the turntable to the left and set the Miter Angle as follows:

* For 45°type crown moldings: 35.3° (	mark)
* For 38°type crown moldings: 31.6° (	mark)

wTilt the head to the left and set the Bevel Angle as follows:

* For 45°type crown moldings: 30° (	mark)
* For 38°type crown moldings: 33.9° (		mark)

ePosition the crown molding so that the lower surface (B in Fig. 28) contacts the fence as in Fig. 33.

			Head					Head
			Bevel Angle Scale					Bevel Angle Scale
q						w			e
				r
				Fence		Fence
				Base					Base
Miter	Ang	le Scale		Turnt	able	Miter	An	gle Scale	Turnt	able
			Fig. 30					Fig. 32
Fence						Fence
	A			B		B			A
			Table on Base					Table on Base
			Fig. 31					Fig. 33

(3)Setting to cut crown moldings at positions q and r in Fig. 29 (see Fig. 34; tilt the head to the right): q Turn the turntable to the right and set the Miter Angle as follows:

* For 45°type crown moldings: 35.3° (	mark)
* For 38°type crown moldings: 31.6° (	mark)

wTilt the head to the right and set the Bevel Angle as follows:

*For 45°type crown moldings: 30° ( mark)

* For 38°type crown moldings: 33.9° ( mark)

ePosition the crown molding so that the upper surface (B in Fig. 28) contacts the fence as indicated Fig. 35.

(4)Setting to cut crown moldings at positions w and e in Fig. 29 (see Fig. 36; tilt the head to the right): q Turn the turntable to the left and set the Miter Angle as follows:

* For 45°type crown moldings: 35.3° (	mark)
* For 38°type crown moldings: 31.6° (	mark)

wTilt the head to the right and set the Bevel Angle as follows:

* For 45°type crown moldings: 30° (	mark)
* For 38°type crown moldings: 33.9° (		mark)

ePosition the crown molding so that the lower surface (A in Fig. 28) contacts the fence as in Fig. 37.

21