English
Flange Nut
Flange Nut | Fence (A) |
Fence (B) |
|
Slide Fence (B) | Slide Fence (A) |
|
Nylon Washer
Nylon Washer
Machine Screw
Machine Screw
Fig. 20
(1)Set slide fence (A) and slide fence (B) on fence (A) and fence (B) of the base.
(2)To attach use the four machine screws with nylon washers and flange nuts as shown in Fig. 20.
(3)Adjust slide fence (A) and slide fence (B) to stabilize the workpiece. Adjustable range of slide fence
(A) and slide fence (B) is from 0 to
(4)Confirm the position of slide fence (A) and slide fence (B) on fence (A) and fence (B) with four machine screws tightly so slide fence (A) and slide fence (B) do not move (see Fig. 20).
CAUTION: * Before operation, ensure that the saw blade does not contact slide fence (A) and slide fence (B). In case the saw blade contacts slide fence (A) and slide fence (B), adjust the position of slide fence (A) and slide fence (B) again.
*Maximum
4.Cutting Operation
a Adjusting Line b
| a | b |
Marking | a | b Marking |
(Front View)
Fig. 21
(1)As shown in Fig. 21 the width of the saw blade is the width of the cut. Therefore, slide the workpiece to the
right (viewed from the operator’s position) when length b is desired, or to the left when length a is desired.
(2)Once the saw blade reaches maximum speed, push the handle down carefully until the saw blade approaches the workpiece.
(3)Once the saw blade contacts the workpiece, push the handle down gradually to cut into the workpiece.
(4)After cutting the workpiece to the desired depth, turn the power tool OFF and let the saw blade stop completely before raising the handle from the workpiece to return it to the full retract position.
CAUTION: * Increased pressure on the handle will not increase the cutting speed.
On the contrary, too much pressure may result in overload of the motor and/or decreased cutting efficiency.
WARNING: * Confirm that the trigger switch is turned OFF and the power plug has been removed from the receptacle whenever the tool is not in use.
*Always remove the
17
