Troubleshooting
Problem | Cause |
| Solution | |
|
|
| ||
Operation buttons do | The HOLD/PUSH OPEN | Slide the switch to the center | ||
not function. | switch is set to HOLD. | position. | ||
The unit does not |
|
|
| |
The batteries are exhausted | Replace all four batteries with | |||
operate. | ||||
( | appears). | new ones. | ||
| ||||
|
|
| ||
| The AC power adaptor is | Connect the AC power adaptor | ||
| connected incorrectly. | correctly. | ||
|
|
| ||
| The safety system is activated | Leave the unit for a while and | ||
| due to moisture condensation | restart the unit by turning on the | ||
| (the | indicator appears). | power. | |
|
|
| ||
| Other causes. | Disconnect the power source | ||
|
|
| from the unit, then connect it | |
|
|
| again. | |
|
|
| ||
The tape does not | PAUSE P button is activated | Press PAUSE P or PLAY ( | ||
move. | (the P indicator appears). | button to release pause mode. | ||
|
|
| (See pages 9 and 12.) | |
|
|
| ||
| The tape is wound completely | • Press the =/0 button to | ||
| to the end. | rewind the tape. | ||
|
|
| • Replace the cassette. | |
There is no sound. | The volume is turned down | Press the + button of VOLUME | ||
| completely. | to adjust the volume. | ||
| Incorrect operation of the | Operate the connected | ||
| connected equipment. | equipment as instructed in the | ||
|
|
| Operating Instructions manual. | |
|
|
| ||
| The head may be dirty. | Clean the head with the cleaning | ||
|
|
| cassette. | |
Recording cannot be | The | Close the shutter on the cassette. | ||
made. | the cassette is open. | (See page 7.) | ||
| Incorrect operation of the | See “Connecting with Other | ||
| connected equipment. | Equipment for Recording” on | ||
|
|
| page 15 or refer to the Operating | |
|
|
| Instructions manual of the | |
|
|
| connected equipment. | |
|
|
| ||
| SCMS signal is detected. | Record via the analog | ||
|
|
| connection. (See page 15.) | |
|
|
| ||
Sound is not recorded | Recording level control is set to | Adjust the REC LEVEL control | ||
on the tape. | the minimum level when | correctly. (See page 17.) | ||
| recording via the analog input. |
| ||
|
|
| ||
Increase of noise or | • The head may be dirty. | • Clean the head with the | ||
deterioration of sound. | • Recording has done with the | cleaning cassette. | ||
| head dirty. | • Clean the head with the | ||
|
|
| cleaning cassette and try again. | |
|
|
|
| |
continued
Additional Information
Additional Information
