INSTALLATION INSTRUCTIONS
Installation
■No stand is provided with this product. When installing the monitor, use the optional
The
| • | Use one of the special mount units to install this product. A mount of insufficient |
WARNING |
| strength or inadequate design can cause overturning or dropping and result in fire, |
| electrical shock or injury. Please note that our company assumes absolutely no | |
|
| |
|
| responsibility for personal injuries or property damage caused by use of other |
|
| mount units or improper installation. |
|
| |
| • Installation of the wall mount unit and ceiling mount unit can be dangerous, so do not | |
CAUTIONS | • | attempt this work yourself. Ask your dealer to provide the name of a qualified installer. |
In order to prevent an internal temperature increase, maintain a space of 10cm (4 | ||
|
| inches : For a desktop |
|
| walls, etc., so that the ventilation holes are not blocked.* |
|
| |
| ||
|
|
|
CAUTIONS | • | Have this unit mounted in a stable place. Take measures to prevent it from |
| tumbling down to avoid possible physical injury. | |
|
|
|
Securing to a wall or pillar | 10cm (4 inches) or more | * |
|
| |
1)Using a commercially available cord, chain and clamp, secure the set to a firm wall or | Clamp |
|
|
| |
pillar. |
|
|
| Cord |
|
| or |
|
| chain |
|
Securing desktop |
|
|
1)Using wood screws (two), fasten the set to the clamping screw holes on the rear of the |
|
|
stand as shown. |
|
|
2)Using commercially available wood screws, secure the set firmly in position. | Wood screw |
|
Two places |
|
ENGLISH
Using the optional vertical-mount unit (CMPAK14)
Using the optional
1)Make at least four sets of commercial anchor bolts and screws available to meet various kinds of walls to mount on.
2)Read the instructions supplied with the
3)Prepare the wall surface for anchoring and drilling as needed, as shown in the sketches.
•Make sure that an adequate wall surface strength and a screw holding strength are available.
■Upper left vertical mounting
Plasma display outline
■ Horizontal mounting
SPEAKER TERMINAL 8Ω 8W
Plasma display outline
SPEAKER | SPEAKER |
TERMINAL | TERMINAL |
8Ω 8W | 8Ω 8W |
SPEAKER TERMINAL 8Ω 8W
Driving anchor bolts into a wall surface
Wall surface
Anchor bolt
Hold to 25 mm (1 inch) or below.
Horizontal mounting
Upper left vertical mounting
CAUTION
•The mounted unit should have the indicating lamp at its bottom. Otherwise, an elevated internal temperature rise could cause the unit to fail or fire.
3
