Hitachi CMP420V2 Operating Instructions, Turning Power On and Off, Indicating lamp, Power on

OPERATING INSTRUCTIONS

Indicating lamp

Main power switch

Turning Power On and Off

•To turn the monitor power ON, press the main power switch on the monitor main unit to ON, and then press the SUB POWER button or the ON/OFF or ON button on the remote control.

•To turn the monitor power OFF, press the SUB POWER button or the ON/OFF or OFF button on the remote control, and then press the main power switch on the monitor main unit to OFF.

•During normal use, the main power switch is set in the ON position, and the monitor can then be turned ON/OFF using the SUB POWER button or the ON/OFF button on the remote control.

	Indicating lamp
	Indicating	Power status	Operating
	lamp
	Off	Off	When the main power switch is set
			to OFF.
			When the main power switch is
		Off	ON, and the OFF button on the
	Lights red		remote control or the SUB POWER
		(standby)
			button on the underside of the
			front of the frame is OFF.
			When the main power switch is
			ON, and the ON button on the
	Lights green	On	remote control or the SUB POWER
			button on the underside of the
			front of the frame is ON.
			When the main power switch is
SUB-POWER button			ON, and the ON button on the
		Off	remote control or the SUB POWER
	Lights orange		button on the underside of the
		(Power Save)
			front of the frame is ON.
			However, the state in POWER
			SAVE mode

POWER OFF
button
POWER ON	POWER ON/OFF
	button
button
	VOL
	RGB 1 RGB 2 MUTE VOL

AV1 AV2 AV3 AV4

AUTO PinP SIZE RECALL

MENU

When the indicating lamp lights in orange or the message “No Sync. Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen, there is something unusual about the status of reception.

See “Power Save Mode” or “Symptoms That Seemingly Appear to be Failures.”

ATTENTION

•Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation.

•Turn off the main power switch before leaving the monitor out of use for an extended period of time.

•If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit.

OK

ID ID SET