Hitachi CMP420V2 Component Names Remote control, Loading Batteries, Handling the Remote Control

COMPONENT NAMES (continued)

Remote control

POWER OFF button

POWER ON button

MUTE button

VOL

POWER ON/OFF button

VOLUME UP/DOWN buttons

RGB/VIDEO buttons

PinP button

AUTO button

MENU button

RGB 1	RGB 2	MUTE	VOL
AV1	AV2	AV3	AV4

AUTO PinP SIZE RECALL

MENU

SIZE button

RECALL button

RETURN button

	OK
OK button
ID	ID SET

ID button

SELECT/ADJUST buttons

ID SET button

Loading Batteries

1. Open the battery cover.

• Slide back and remove the battery cover in the direction of the arrow.

2.Load batteries.

•Load two Size AA batteries included observing the correct polarities.

3.Close the battery cover.

•Replace the battery cover in the direction of the arrow and snap it back into place.

Handling the Remote Control

Use the remote control within about 5 m from front of the unit’s remote-control sensor and within 30 degrees on both sides.

With in 30

With in 30 degrees degrees

About 3m About 3m

About 5m

CAUTION

•Do not use new and old batteries together. The batteries could explode or leak, resulting in fires, physical injury, or stains.

•When loading batteries, observe their correct polarities as marked on the product. If loaded in the wrong direction, the batteries could explode or leak, resulting in fires, physical injury, or stains.

ATTENTION

•Do not drop or impact the remote control.

•Do not splash the remote control with water or put it on a wet object to avoid possible failures.

•Before leaving the remote control out of use for an extended period of time, remove the batteries from it.

•If the remote control begins to lack responsiveness, replace the batteries.

•Strong light such as direct sunlight impinging on the photoreceptor of the remote control can cause operational failure. Position this unit to avoid direct contact with such light.