HDECLARATION of Conformity | Hitachi HPW-200EC specification

hDECLARATION OF CONFORMITY

This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions; (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Model Number :	HPW-200EC
Trade Name :	HITACHI
Responsible Party : HITACHI Home Electronics(America),Inc.
Address :	3890 Steve Reynolds Blvd. Norcross, Georgia 30093

Telephone Number : (770) 279-5600

Image 57

Hitachi HPW-200EC manual HDECLARATION of Conformity

Contents

Handheld PC Hardware Users Guide Information to Users ICES-003 Statement Important Safety InstructionsPage Page Page Industry Canada Terminal Equipment Statement Page Page MIC Welcome Picture from the Bottom of the Handheld PC Running your Handheld PC Batteries and power Operating your Handheld PC with the Main batteries To insert the rechargeable Li-ion battery pack To change the main battery Operating your Handheld PC with the AC adapter Charging rechargeable Li-ion battery pack Notification LED Using the stylus Pen Wireless infrared transferTo use the stylus Pen Left Side View of Handheld PC Interface cable PC card slot To insert a PC cardTo remove a PC card Using the CF card. also known as Compact Flash card To insert a CF cardTo remove a CF card To use a modem RAM/ROM Slot To change ROM board VGA Output Of Pocket PowerPoint Viewer Installation & Start-UpGeneral Description Usage ESC Using the Voice Recorder Page To assign application to User1 and User2 To use Quick Launch Key To use and key Adjusting the display contrastTo increase display contrast To decrease display contrast Resetting your Handheld PC To perform a simple resetTo perform a full reset Precautions Hardware SpecificationsPhysical Description and Features Weight Peripheral and Transfer Interface Power CF Card Compatibility PC Card Compatibility Compatibility Specification Error CorrectionStandard Data Compression AT= x Write to Selected S-Register Re-execute CommandAT? Read Selected S-Register Answer En Command Echo Dn DialDial Modifiers Hn Disconnect and hook control Fn Select Modulation Compatibility onlyModem Identification Mn Speaker Control Set Pulse Dialing as a default On Return to On-Line Data ModeSn Access S-Register Set Tone Dial Default Xn Extended Result Codes Control RING, no CARRIER, ERROR, no DIALTONE, Connect Rate Summary of Supported Result Codes Fn Restore Default Configuration Zn ResetYn Long Space Disconnect Cn DCD Data Carrier Detect Option Qn Mode Selection Mn Mode SelectionGn Select Guard Tone Kn Flow Control Wn Store Current Configuration Display Current ConfigurationYn Selects a Default Reset Profile \Nn Selects Operating Mode 1.AT% Commands Enable/Disable Data Compression RingConnect 1200 Connect 75 Connect 1200 Busy Compression None Compression V.42bis S1 Ring Counter S0 Number of Rings to Auto-Answer S2 Escape Character S8 Pause Time For Dial DelayS3 Carriage Return Character S4 Line Feed Character S12 Escape Guard Time S11 Dtmf Tone DurationS36 Lapm Failure Control S37 Desired Line Connection Speed S83 EC Negotiation timeout S38 Delay Before Forced Hang Up +Fcommand? Report Active Configuration +FCLASS=n Select Service Class+Fcommand=? Report Operating Capabilities Fax Modulation Table Value Modulation & Speed +FTM=n Transmit Data +FRS=n Receive Silence+FRM=n Receive Data +FTH=n Transmit Data with Hdlc FramingPage Page HDECLARATION of Conformity Spring,1998