|
|
| n - Value in ATXn Command |
|
| |||
Short Form | Long Form | 0 | 1 | 2 | 3 |
| 4 | 5 |
65 | CARRIER 33600 | Y | Y | Y | Y |
| Y | Y |
|
|
|
|
|
|
|
|
|
67 | COMPRESSION: V.42bis | Y | Y | Y | Y |
| Y | Y |
|
|
|
|
|
|
|
|
|
68 | CONNECT 31200 | 1 | Y | Y | Y |
| Y | Y |
69 | COMPRESSION: NONE | Y | Y | Y | Y |
| Y | Y |
70 | CONNECT 33600 | 1 | Y | Y | Y |
| Y | Y |
76 | PROTOCOL: NONE | Y | Y | Y | Y |
| Y | Y |
|
|
|
|
|
|
|
|
|
77 | PROTOCOL: LAPM | Y | Y | Y | Y |
| Y | Y |
|
|
|
|
|
|
|
|
|
85 | RRING | N/A | N/A | N/A | N/A |
| N/A | Y |
|
|
|
|
|
|
|
|
|
86 | NO BONGTONE | N/A | N/A | N/A | N/A |
| N/A | Y |
|
|
|
|
|
|
|
|
|
Yn - Long Space Disconnect
This command controls the generation and response to long space disconnect.
Y0 Disables long space disconnect (default)
Y1 Enables long space disconnect
Zn - Reset
This command will force the modem to perform a soft reset. If nonvolatile memory is supported it will restore the profile according to the parameter of the command.
Z0 Reset and restore stored profile 0
Z1 Reset and restore stored profile 1
&Cn - DCD (Data Carrier Detect) Option
This command informs the modem how to control DCD signal (V.24 circuit 109).
&C0 | DCD remains ON at all times |
&C1 | DCD follows the state of the carrier (default) |
&Dn - DTR (Data Terminal Ready) Option
This command informs the modem how to treat DTR signal (V.24 circuit 108).
&D0 | The modem ignores DTR signal. (default) |
&D1 | In |
| command mode (same as escape sequence). |
&D2 | The modem hangs up on DTR transition from ON to OFF. |
&D3 | The modem performs soft reset on DTR transition from ON to OFF. |
&Fn - Restore Default Configuration.
The modem restores the default ( "factory" ) configuration.
&F0 | Restore default configuration |
&F1 | Restore default configuration |
Note: The modem has only one default configuration.
42
