Hitachi PJ-TX100 Troubleshooting, Related messages, Message, Description, hours, recommended

Troubleshooting

Troubleshooting

Related messages

When the unit's power is on, messages such as those shown below may be displayed. When any such message is displayed on the screen, please respond as described below. If the same message is displayed after the treatment, or if a message other than the following appears, please contact your dealer or service company.

Although these messages will be automatically disappeared around several minutes, it will be reappeared every time the power is turned on.

Message	Description
CHANGE THE LAMP	The time the lamp timer has counted is approaching
	2000 hours.
AFTER REPLACING LAMP,	Preparation of a new lamp, and an early lamp change is
RESET THE LAMP TIMER.	recommended. After you have change the lamp, please be
	sure to reset the lamp timer.
CHANGE THE LAMP	The time the lamp timer has counted is approaching
	2000 hours, so a lamp change within ** hours is
AFTER REPLACING LAMP,	recommended.
RESET THE LAMP TIMER.	When lamp usage reaches 2000 hours, the power will
	automatically be turned off. Please change the lamp by
THE POWER WILL TURN OFF	referring to the section “Lamp”. After you have changed the
AFTER ** hr.	lamp, please be sure to reset the lamp timer.
CHANGE THE LAMP	As the time the lamp timer has counted has reached
AFTER REPLACING LAMP,	2000 hours, the power will soon be automatically
RESET THE LAMP TIMER.	turned off.
	Please immediately turn the power off, and change the lamp
THE POWER WILL TURN OFF	by referring to the section “Lamp”. After changing the lamp,
AFTER 0 hr.	please be sure to reset the lamp timer.
NO INPUT IS DETECTED	There is no input signal.
	Please confi rm the signal input connection, and the status
ON ***
	of the signal source.
	(This table is continued to the following page.)

ENGLISH

NOTE • A lamp has a fi nite product life. Lamps are characterized by the fact that, after long hours of usage, a lamp will no longer light up, or the lamp will break or burst, etc. This projector is equipped with an automatic shut-down function, such that the power will automatically be turned off when lamp usage time has reached 2000 hours. Please be aware, however, that among lamp types, there are major differences in product lifetimes; a lamp may thus fail to light even prior to the functioning of the automatic shut-down function of this projector.

35