Hobart FP400 manual Installation, Unpacking, Location, Leveling, Electrical Connection

Installation, Operation and Care of

HOBART MODEL FP400 FOOD PROCESSOR

PLEASE KEEP THIS MANUAL FOR FUTURE USE

GENERAL

The FP400 Food Processor is used for slicing, shredding, grating, Julienne cutting and dicing vegetables, fruits, or cheese. A wall rack, and a wide range of slicer, shredder, and dicing plates are available accessories.

The machine is built for 208-240 volt, 60 Hertz, 3 phase electrical supply.

INSTALLATION

Before installing, verify that the electrical service agrees with the specifications on the data plate located on the back of the machine.

UNPACKING

Immediately after unpacking the FP400, check for possible shipping damage. If the food processor is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.

LOCATION

Place the FP400 in its installation location. Allow adequate space to sides and rear to swing pusher plate feed attachment and open feed cylinder.

LEVELING

Turn the adjustable feet to level the machine side-to-side and front-to-back.

ELECTRICAL CONNECTION

WARNING: THE ELECTRICAL CORD HAS A FOUR-PRONGED GROUNDING PLUG WHICH MUST BE CONNECTED TO A PROPERLY GROUNDED RECEPTACLE. IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT REMOVE THE GROUNDING PRONG FROM THE PLUG.

– 4 –