Hobart FP400 manual Pusher Plate, Use the decoring screw to secure the plates to the knife shaft

Models: FP400

1 16

Page 10

PL-52971

ATTACHMENT

LOCKING KNOB

PUSHER PLATE FEED

ATTACHMENT SHAFT

STOP PAD

CYLINDER

TUBE

PL-52972

Fig. 9

Fig. 10

PUSHER

PLATE

HANDLE

FEED

CYLINDER

TUBE

1.Press the STOP button.

2.Fit the feed cylinder with three internal knives (see Fig. 8).

3.Move the pusher plate handle (Fig. 10) all the way up.

4.Insert the pusher plate attachment shaft (Fig. 10) into the feed cylinder tube (Fig. 10).

5.Press the pusher plate attachment down and turn the locking knob counterclockwise.

6.When removing, press the stop pad (Fig. 10) down, swing the pusher plate attachment out clockwise and remove it.

– 10 –

Image 10

Contents

ML-104751 N S TRUCT I ONSMODEL FP400 FOOD PROCESSOR FORM 33966 Rev. ATABLE OF CONTENTS MODEL FP400 FOOD PROCESSOR Shown with Feed Hopper Attachment HOBART CORPORATIONPLEASE KEEP THIS MANUAL FOR FUTURE USE GENERAL Installation, Operation and Care of HOBART MODEL FP400 FOOD PROCESSORINSTALLATION UNPACKINGLOCKING KNOB LOCKING HANDLE START-UP TESTINGVERIFY CORRECT ROTATION PUSHER PLATE FEED CYLINDER OPENINGOPERATION CONTROLS FigSlicing, Shredding, Grating, and Julienne Cutting INSTALLING THE CUTTING TOOLSDicing and French Fries FEED CYLINDER HINGE PINS INSTALLING AND REMOVING THE FEED CYLINDER FigREMOVING THE CUTTING TOOLS LOCKING HANDLEFeed Hopper INSTALLING AND REMOVING THE FEED ATTACHMENTSUse the agitator device to secure the plates to the knife shaft FEED HOPPER ATTACHMENT LOCKING KNOB Pusher PlateUse the decoring screw to secure the plates to the knife shaft FEED CYLINDER TUBEWhen used with dicing grid, use USING THE FOOD PROCESSORSlicers only the 3⁄ 4 19 mm dicing gridJulienne Cutters Crimping SlicerGraters and Shredders CLEANING REPLACEMENT DICING GRIDS MAINTENANCESERVICE POSSIBLE CAUSE TROUBLESHOOTINGSYMPTOM SUGGESTED ACTIONPOSSIBLE CAUSE TROUBLESHOOTING ContdSYMPTOM SUGGESTED ACTION