Hobart ML-124061, HQC45 Holding Freezer Temperature, SURF PROTECTION OFF 1=ON2=OFF, Printer Paper

HOLDING FREEZER

TEMPERATURE: -6

For Example:

The setting for the air temperature in freezer hold mode is shown. Air temperature will be maintained between the holding temperature and holding temperature plus differential.

Holding Freezer Temperature = –6°F. Differential = 6 F°. Temperature will fluctuate between –6°F and 0°F.

Temperature Range Preset Holding Freezer Temp.

Freezer Hold Mode – 32° F to 20° F – 6° F

SURF PROTECTION: OFF

1=ON2=OFF

Enter a value within the range. Press [YES] to continue.

This applies only when operating in a Chill mode. When ON, the blasting air temperature is raised to 28°F during the last third of a timed (manual) chill cycle or when all three probes are within 5 F° of the target temperature during an automatic chill cycle.

Range of Acceptable Values	Preset Value
1 or 2	2 = Off

Select [1] or [2]. Press [YES] or [NO] to return to the main menu.

PRINT MODE — Press the [PRINT] key. This mode can be accessed at any time without interrupting the ongoing chill cycle.

SELECT PRINT MODE 1=24 HR 2=LAST CHILL

SELECT PROBE NUMBER 1->3 OR 0 FOR ALL

Select between printing a report including all chill data since 12:00 midnight or only the previous chill cycle.

Press [0] to report all probes. Or, press [1], [2], or [3] to report only the selected probe. The display returns to whatever menu was displayed before the [PRINT] key was pressed.

NOTE: Do not pull paper through printer slot.

PRINTER PAPER

Printer paper is available from Hobart — order part number 282051.

LOADING PRINTER PAPER

CAUTION: Do not touch exposed electrical parts, bare wires or circuit boards. This could cause electrostatic discharge and could damage the controller.

Do not pull paper through printer. Use the Line Feed Switch to advance any remaining paper through the printer. Compress the coil spring on the left end of the roll to release the core from the holders on each side. Follow instructions inside control box for loading printer paper. Once loaded, it may take a minute or more for paper to advance through the printer slot.

SETTING THE TIME AND DATE —

1=INPUTS 2=OUTPUTS 3=CLOCK 4=PRINTER

ENTER NEW TIME

XM HH:MM:SS

ENTER NEW TIME 0=AM, 1=PM XX:XX:XX

ENTER NEW DATE

MM/DD 05/20/2000

Open the control box door. Press both the Service Switch (see Fig. 5) and the [9] key (on front keypad) at the same time.

The service menu will appear. Press [3] to select Clock.

Enter the new hours, minutes, seconds: HH-MM-SS (6 digits). Press [0] for AM or [1] for PM. Press [YES].

Enter the new month, day and year: MM-DD-YYYY (8 digits). Press [YES]. Press [NO] two times to exit to the main menu.

– 11 –