Scanning Features
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is entered. The range for this setting is from 1 to 255 seconds in
Follow these instructions to set this feature:
1.Determine the desired setting.
2.Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 = 020, etc.
3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program- ming Mode.
4.Scan the barcode: SELECT SCANNING ACTIVE TIME SETTING.
5.Scan the appropriate three digits from the keypad in Appendix E, Keypad, that rep- resent the duration which was determined in the steps above. You will hear a two- beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program- ming Mode.
This completes the procedure. See Table 4 for some examples of how to set this feature.
Table 4. Scanning Active Time Setting Examples
STEP | ACTION |
| EXAMPLES |
| ||
|
|
|
|
|
| |
1 | Desired Setting | 1 Second | 90 Sec. (1.5 min.) | 180 Sec. (3 min.) | 255 Seconds (4.25 min.) | |
|
|
|
|
|
| |
2 | Pad leading zero(es) | 001 | 090 | 180 | 255 | |
|
|
|
|
|
| |
3 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
| ||
|
|
|
|
| ||
4 | Scan SELECT SCANNING ACTIVE TIME SETTING |
|
|
| ||
|
|
|
|
|
| |
5 | Scan Three Characters From | ‘0’, ‘0’ and ‘1’ | ‘0’, ‘9’ and ‘0’ | ‘1’, ‘8’ and ‘0’ | ‘2’, ‘5’ and ‘5’ | |
Appendix E, Keypad | ||||||
|
|
|
|
| ||
|
|
|
|
|
| |
6 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
| ||
|
|
|
|
|
| |
Product Reference Guide | 35 |
