Datalogic Scanning PD7100 manual NAK Character Setting Examples

RS-232/USB-Com Interfaces

NAK Character

This setting specifies an ASCII character or hex value to be used as the NAK charac- ter. ASCII characters or any hex value from 0 to 0xFF can be selected.

NOTE

Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal operation of these characters. 8-bit data is not recognized when the option Data Bits has been set as 7

Data Bits.

To set this feature:

1.Determine the desired character or value.

2.Use the ASCII Chart on the inside back cover of this manual to find the hex equiv- alent for the desired character/value.

3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program- ming Mode.

4.Scan the barcode: SELECT NAK CHARACTER SETTING.

5.Scan the appropriate two alpha-numeric characters from the keypad in Appendix E, Keypad, that represent the desired character/value in step 1 above. The second character will cause a two-beep indication.

6.Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program- ming Mode.

This completes the procedure. See Table 9 for some examples of how to set this fea- ture.

Table 9. NAK Character Setting Examples

STEP	ACTION				EXAMPLES
1	Desired Character/Value		NAK	$		@	>
2	Hex equivalent		0x15	0x24		0x40	0x3E
3	Scan ENTER/EXIT PROGRAMMING MODE
4	Scan SELECT ACK CHARACTER SETTING
5	Scan Two Characters From	‘1’ and ‘5’		‘2’ and ‘4’		‘4’ and ‘0’	‘3’ AND ‘E’
	Appendix E, Keypad
6	Scan ENTER/EXIT PROGRAMMING MODE

60 PowerScan® PD7100 Corded