Intercode Delay
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable range for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1.Determine the desired setting.
2.Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc
3.Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program- ming Mode.
4.Scan the barcode: SELECT INTERCODE DELAY SETTING.
5.Scan the appropriate two digits from the keypad in Appendix E, Keypad, that rep- resent the duration which was determined in the steps above. You will hear a two- beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start again at the beginning.
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program- ming Mode.
This completes the procedure. See Table 16 for some examples of how to set this feature.
Table 16. Wedge Intercode Delay Examples
STEP | ACTION |
|
| EXAMPLES |
| |
|
|
|
|
|
|
|
1 | Desired Setting | No Delay | 5 Seconds |
| 60 Seconds | 99 Seconds |
|
|
|
|
|
|
|
2 | Pad with leading zero(es) | 00 | 05 |
| 60 | 99 |
|
|
|
|
|
|
|
3 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
|
| |
|
|
|
|
|
| |
4 | Scan SELECT INTERCODE DELAY SETTING |
|
|
|
| |
|
|
|
|
|
|
|
5 | Scan Two Characters From | ‘0’ and ‘0’ | ‘0’ and ‘5’ |
| ‘6’ and ‘0’ | ‘9’ AND ‘9’ |
Appendix E, Keypad |
| |||||
|
|
|
|
|
| |
|
|
|
|
|
|
|
7 | Scan ENTER/EXIT PROGRAMMING MODE |
|
|
|
| |
|
|
|
|
|
|
|
Product Reference Guide | 83 |
