.A complete Parts List is available at www.HobartWelders.com

SECTION 7 − MAINTENANCE & TROUBLESHOOTING

7-1. Routine Maintenance

! Disconnect power

. Maintain more often

before maintaining.

during severe condi-

 

tions.

n = Check

Z = Change

~ = Clean

l = Replace

* To be done by Factory Authorized Service Agent

 

Reference

3 Months

lDamaged Or Unreadable Labels

lRepair Or Replace Cracked Weld Cable

~Clean And Tighten Weld Terminals

6 Months

OR

~Inside Unit

7-2. Overload Protection

1

1 Supplementary Protector CB1

CB1 protects unit from overload. If CB1 opens, unit shuts down.

Reset supplementary protector.

802 441

7-3. Drive Motor Protection

Drive motor protection circuit protects drive motor from overload. If drive motor becomes inoperative, release gun trigger and wait until protection circuit resets allowing drive motor to feed wire again.

OM-925 Page 26

Page 30
Image 30
Hobart Welding Products 217 694E, OM-925 Maintenance & Troubleshooting, Routine Maintenance, Overload Protection, Months