SECTION 4 − INSTALLATION
4-1. Installing Welding Gun
1
4-2. Installing Work Clamp
1
2
Tools Needed:
5
3/8, 7/16 in
4
2
3
3
4
1Drive Assembly
2Gun Securing Thumbscrew
3Gun End
Loosen thumbscrew. Insert end through opening until it bottoms against drive assembly. Tighten thumbscrew.
Welding gun must be inserted completely to prevent leakage of shielding gas.
4 Gun Trigger Leads
Insert leads, one at a time, through gun opening on front panel. Connect female friction terminals to matching male terminals in unit. Polarity is not important.
Close door.
803
1Nut
2Work Cable From Unit
3Work Clamp
4Screw
5Work Clamp Tabs
Bend tabs around work cable.
.Hardware must be tightened securely to prevent arcing and heating at connection.
802 456
Return To Table Of Contents |
