Hobart Welding Products OM-925 217 694A manual Operation, Controls

SECTION 5 − OPERATION

5-1. Controls

1 2

2

O N

O F F

W I R E F E E DP O W E R

34

DO NOT SWITCH

WHILE WELDING

1P U R G E

	V
	V O LT A G E
3	4

Ref. 217 617-A

1 Wire Speed Control 3 Voltage Switch 4 Voltage Switch - “Purge” Position

Use control to select a wire feed speed. As Voltage switch setting increases, wire speed range also increases (see weld setting label in welding power source or Sections 5-2or 5-3,as applicable).

2 Power Switch

The higher the selected number, the thicker the material that can be welded (see weld setting label in welding power source or Sections 5-2and 5-3,as applicable). Do not switch under load.

.Switch must “click” into detent position 1, 2, 3, 4, or purge for proper contact.

In purge position, fan runs but there is no weld output or wire feed. Use “PURGE” setting when adjusting gas flow at the regulator.

Return To Table Of Contents OM-925 Page 19