■FUNCTION TABLE of the NUMBERED BUTTONS
ENGLISH
■Notes :
•Some functions for each component may not be available or may work differently.
•Depending on other kinds of components that are available for each DEVICE button, some functions may not be available or may work differently, too.
•For details about functions, refer to the operating instructions of each component.
ENTERING A SETUP CODE
•This remote control can control up to 4 different components.
•Before operating video components other than this unit with using this remote control, the setup code for each component should be entered.
1. Turn on the component you want to control.
2. Find the setup code according to the type and the brand name of your component, referring to "Setup Code Table" on page 57.
3. Press and hold down both the ENTER button and the DEVICE button you want for more than 1 second.
• The SET LED will flicker once.
■Note :
•The MAIN button is unavailable for the components other than this unit.
4. Enter a 3 digit code.
Example) When entering "001".
•If entering is performed successfully, the SET LED will flicker twice.
•To be sure that the setup code is correct, press the POWER ON(or STANDBY) button, aiming the remote control at the remote sensor on the component. If your component is turned off, the setup code is correct.
•When your component is not turned off, repeat the above steps 2 to 4, trying each code for your component until you find one that works.
■Notes :
•If the SET LED did not flicker twice, then repeat the above steps 3 to 4 and try entering the same code again.
•Manufacturers may use different setup codes for the same product category. For that reason, it is important that you check to see if the code you have entered operates as many controls as possible. If only a few functions operate, check to see if another code will work with more buttons.
5. Repeat the above steps 1 to 4 for each of your components.
13
