Homelite HG3510 starting the unit, danger, Lubrication, Fuel, Pre-Start Preparation

Models: HG3510

1 44
Download 44 pages 13.58 Kb
Page 10
Image 10
LUBRICATION

LUBRICATION

DO NOT attempt to start this engine without filling the crank case with the proper amount and type of lubricant. (See the accompanying engine manual for this information.) Your genera- tor has been shipped from the factory without lubricant in the crankcase. Operating the unit without lubricant can damage the engine.

Fill the engine with lubricant according to the engine man- ual. For units with a dipstick, fill lubricant to the proper level. Units without a dipstick should be filled to the top of the opening of the lubricant fill.

FUEL

Fill the tank with clean, fresh unleaded automotive gasoline. Regular grade gasoline may be used provided a high octane rating is obtained (at least 85 pump octane). We recommend always using a fuel stabilizer. A fuel stabilizer will minimize the formulation of fuel gum deposits during storage. The fuel sta- bilizer can be added to the gasoline in the fuel tank, or into the gasoline in a storage container. Do not use E85 fuel.

FUEL caution:

Do not overfill the tank. Keep maximum fuel level 1/4 inch below the top of the fuel tank. This will allow expansion in hot weather and prevent overflow.

starting the unit

starting the unit warning:

Gasoline is very dangerous. Serious injury or death can result from fire caused by gasoline contacting hot surfaces.

Do not fill fuel tank with engine running.

Do not spill fuel while refilling tank.

Do not mix lubricant with gasoline.

Follow all instructions and warnings in the engine manual.

PRE-START PREPARATION

Before starting the generator, check for loose or missing parts and for any damage which may have occurred during shipment.

PRE-START PREPARATION warning:

This generator must not be operated without all factory installed heat shields in place. Failure to comply may cause the fuel tank to overheat and result in personal injury from fire.

STARTING THE ENGINE

Check lubricant level and fuel.

Disconnect all electrical loads from the unit.

Open fuel shut off valve.

Adjust choke as necessary.

Set the engine switch to the “ON” position.

Pull on the starter rope with fast steady pull. As the engine warms up, readjust the choke.

STARTING THE ENGINE danger:

Provide adequate ventilation for toxic exhaust gases and cooling air flow.

Do not start or run the generator in an enclosed area, even if door or windows are open.

Engines give off carbon monoxide, an odorless, colorless, poison gas.

Breathing carbon monoxide can cause nausea, fainting or death.

Manual background caution:

Allow generator to run at no load for five minutes upon each initial start-up to permit engine and generator to stabilize.

10

Page 10
Image 10
Homelite HG3510 starting the unit, danger, Lubrication, Fuel, Pre-Start Preparation, Starting The Engine